| Accessories with Your System | 218
Viewing the Information of Bluetooth Wireless Microphones
Procedure
1. Do one of the following:
• On your web user interface, go to Setting > Wireless Microphone.
• On your VCS, go to More > Setting > Video & Audio > Wireless Microphone, and select the
desired wireless microphone.
• On your CTP20, go to Setting > Audio > Wireless Microphone, and select the desired wireless
microphone.
2. Select a desired microphone to view the information.
Finding the Registered CPW90-BT
Procedure
1. Do one of the following:
• On your web user interface, go to Setting > Wireless Microphone.
• On your VCS, go to More > Setting > Video & Audio > Wireless Microphone.
• On your CTP20, tap Setting > Audio > Wireless Microphone.
2. Select a wireless microphone and then select Find.
The mute indicator LED on the CPW90-BT flashes red and green alternately.
Using CTP20
The CTP20 supports wired and wireless connections. The PVT980/PVT950/VC880/VC800/VC500 can
connect up to 4 CTP20s and the VC200 supports only one CTP20. VP59 cannot be used with a CTP20.
• Wired Connection to CTP20
• Wireless Connection to CTP20
• Using Multiple CTP20s for Collaboration
• Importing an Existing Whiteboard during a Call
• Saving or Sharing Whiteboard Source Files
Wired Connection to CTP20
After connected to the VC Hub/Phone port via the network cable, CTP20 will be connected to the VCS
automatically. For more information, refer to Yealink_CTP20_Quick_Start_Guide.
Wireless Connection to CTP20
If the VC Hub/Phone port of the VCS codec is used, you can connect the CTP20 to the PoE switch for power
supply, also to the wireless access point provided by the VCS codec.
Before you begin
Make sure the Wireless AP is enabled and the codec is connected to WF50.
About this task
If the codec connects to the wireless network and the Wireless AP is disabled, the CTP20 cannot use the
wireless connection.
To Next Page
Loading...
