| Configuring Video Settings | 148
2. Configure and save the following settings:
Parameter Description Configuration Method
HDMI1
Set the output resolution of the
HDMI 1 display device.
• Auto-select the highest
output resolution
automatically.
• The available output
resolutions (The available
resolutions depend on the
monitor you are using).
Default: Auto.
Web user interface
CP960 Conference Phone
HDMI 2 (it is not applicable to
VP59)
Enable or disable the HDMI 2
display.
Default: On.
Web user interface
HDMI 2 (it is not applicable to
VP59)
Set the output resolution of the
HDMI 2 display device.
• Auto-select the highest
output resolution
automatically.
• The available output
resolutions (The available
resolutions depend on the
monitor you are using).
Default: Auto. It is configurable
only when HDMI 2 display is
enabled.
Web user interface
CP960 Conference Phone
Configuring VC200 Experimental Access (Auto Framing)
The experimental access feature currently includes the auto framing, which is mainly based on face
detection. Real-time detection and position tracking are performed on all faces in the conference room.
The camera can be automatically adjusted according to the number of participants and their positions. All
participants are covered in the output screen captured by the camera.
About this task
Attention: Note the following points when using the VC200 experimental access feature:
• After the auto framing is enabled, other devices cannot perform PTZ control on the VCS camera,
and the camera preset function does not take effect.
• The number of face detections on the VC200 can support up to 8 faces simultaneously in a range
of 5 meters.
• The experimental access is a new feature that Yealink is still researching and developing.
It is available to users for trial use in advance, but this feature is still unstable now. It is not
recommended for daily use.
To Next Page
Loading...
