| Configuring the Audio Settings | 125
Specifying an Available Audio Output
You can specify an available audio output if you do not want to use the default audio output device.
Procedure
1. Do one of the following:
• On your web user interface, go to Setting > Video & Audio > Audio Settings.
• On your VCS:
On your VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Video & Audio > Audio
Settings.
On your VC200, go to More > Setting > Video & Audio.
On your VP59, tap Setting > Audio.
• On your CTP20, tap Setting > Audio.
2. Configure and save the following settings:
Parameter Description Configuration Method
Audio Output/Extended Audio
Output
Specify the audio output for the
system.
The supported types are as
follows:
• Auto- the audio output
device with the highest
priority.
• VCS Phone - the CP960
conference phone. (it is not
applicable to VP59)
• HDMI - the built-in
speakerphone of the monitor.
If you connect two monitors
to your system, only the
HDMI 1 port is available for
audio output.
• Line Output –the
speakerphone connected to
VC880/VC800/VC200/PVT980
codec.
• USB to Line output -
the audio output device
connected to the USB port on
the VC500/PVT950 codec via
a USB to Line output adapter.
Note: the default value is Auto.
If VCS Phone is set as the audio
output device manually or
automatically, the audio input
device must be VCS Phone.
Web user interface
Endpoint
CTP20
Note:
The system will start EQ self-adaption to optimize the acoustic effect automatically when the
audio output switches to HDMI or Line Output/USB to Line out.
To Next Page
Loading...
