| Configuring Camera Settings | 168
Configuring FECC (H.323) Protocol
When logging in to the StarLeaf platform or using an H.323 account, you can enable the FECC (H.323)
protocol for H.323 calls. To control the far-site camera, both parties should enable this protocol
simultaneously.
Procedure
1. On your web user interface, go to Account > VC Platform > Platform Type > StarLeaf or Account >
H.323.
2. Configure and save the following settings:
Parameter Description Configuration Method
FECC (H.323)
Enable or disable FECC(H.323).
Enables FECC (H.323) protocol,
so that the remote can control
the near camera.
Default: On.
Web user interface
Configuring FECC (SIP) Protocol
When using SIP account, SIP IP call, or logging in to Zoom, Pexip, BlueJeans, EasyMeet, Videxio, or a custom
third-party platform, you can enable FECC (SIP) control for SIP calls. To control the far-site camera, the call
parties should enable this protocol simultaneously.
Procedure
1. Do one of the following:
• On your web user interface, go to Account > VC Platform > Video Conference Platform >
Platform Type > Zoom/Pexip/BlueJeans/EasyMeet /Videxio/Custom.
• On your web user interface, go to Account > SIP Account/SIP IP Call.
2. Configure and save the following settings:
Parameter Description Configuration Method
FECC (SIP)
Enable or disable the FECC
(SIP) protocol for the far site to
control the near camera.
Note:
For Zoom/Pexip/BlueJeans/
EasyMeet/Videxio/Custom and
SIP IP call, BFCP is enabled by
default.
For SIP account, BFCP is disabled
by default.
Web user interface
To Next Page
Loading...
