| Configuration Methods | 39
Configuring an Administrator Password
The default administrator name is “admin” and the administrator password is “0000”. Only the user with the
administrator permission can change the password. For security reasons, you should change them as soon
as possible. The administrator password for the system supports ASCII characters 32-126 (0x20-0x7E).
Procedure
1. Do one of the following:
• On your web user interface, go to Security > Security.
• On your VCS, go to More > Setting > Advanced > Password Reset.
On your VP59, tap Setting > Advanced > Password Reset.
• On your CTP20, tap Setting > Advanced > Password Reset.
2. Configure and save the following settings:
Parameter Description Configuration Method
User Type Select the administrator. Web user interface
Old Password/Current
Password
Enters the old administrator
password.
Default: “0000 ”.
Web user interface
Endpoint
CTP20
New Password
Configure a new administrator
password.
Note: You can leave the
password blank.
Web user interface
Endpoint
CTP20
Confirm Password
Enters the new configured
administrator password.
Note: The entered password
must be the same as the one
configured by the parameter
“New Password”.
Web user interface
Endpoint
CTP20
Enabling the User Role
If you enable the user role, users can access basic configurations such as contacts. The default user name is
“user” and the password is “1234”.
Procedure
1. On your web user interface, go to Security > Security.
2. Configure and save the following settings:
Parameter Description Configuration Method
User Mode Select User. Web user interface
User Mode Enables the user role.
Default: Disabled.
Web user interface
To Next Page
Loading...
