| Configuring Network Settings | 55
Procedure
1. Do one of the following:
• On your web user interface, go to Network > LAN Configuration > IPv4 Config.
• On your VCS:
On your VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Wired
Network > IPv4.
On your VC200, go to More > Network > Wired Network > IPv4.
On your VP59, go to Setting > Advanced > Wired Network > IPv4.
• On your CTP20, tap Setting > Advanced > Wired Network > Wired Network > IPv4.
2. Configure and save the following settings:
Parameter Description Configuration Method
DHCP
Enable or disable the system to
obtain network settings from the
DHCP server.
Note: the default value is On.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20
Static IP
Enable or disable the system
to use manually configured
network settings.
Note: the default value is Off.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
IP Address
Configure the IPv4 address
assigned to the system.
Note: It is configurable only
when the network type is
selected as Static IP. If you
change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20
Subnet Mask
Configure the subnet mask
assigned to the system.
Note: It is configurable only
when the network type is
selected as Static IP.
If you change this parameter, the
system will reboot to make the
change take effect.
Web user interface
Endpoint
CTP20
To Next Page
Loading...
