Call routing
199
System functions and features as of R3.0
syd-0367/1.3 – R3.0 – 03.2013
6. 3. 3. 3 Not Forwarding a Call if busy
If the caller is to obtain the busy tone when the user is busy, the following configu-
ration recommendations must be observed:
• Do not configure an alternative destination if busy (leave the CDE if busy setting
blank).
• Do not configure Call Forwarding on No Reply if busy
• Disable call waiting on exchange connections in the system configuration
• Disable local call waiting using *04
Note:
Disable Call waiting if a fax machine is connected to an internal termi-
nal interface.
6. 3. 3. 4 Release Destination if Incoming Dialling is Incom-
plete
1)
If the direct dial number is incompletely dialled the outside call will be routed to
the call distribution element allocated to the trunk group after 8 to 15 seconds (de-
pending on the country) and then forwarded to the destinations entered there.
1)
Only in countries in which digit-by-digit DDI is implemented in their public exchanges.
To Next Page
Loading...
