Features
362
System functions and features as of R3.0
syd-0367/1.3 – R3.0 – 03.2013
9. 2. 9 Operating the features on the terminal
9. 2. 9. 1 Feature activation
With system phones, features can be operated in the following ways:
• Menu-supported with Foxkey for all system phones with a display and for the
Aastra 1560 / Office 1560 PC operator console
• Using the Foxkey alone, for system phones without a display
• via function keys (see Tab. 149)
• With suffix dialled digits, in a specific connection status (e.g. suffix dialling digit 2
switches back and forth between two connections) For this the DTMF mode
must not be activated on the system phone.
With commercially available system terminals by other manufacturers, features can
be operated in the following ways:
•ISDN terminals:
– By menu for ISDN services supported by the system on the S bus as per ETSI
(see Tab. 381).
– With */# function codes
• Analogue terminals: With */# function code or control key
Changing the standard mode for DTMF
A number of functions can be operated in suffix dialling (e.g. for voice mail system)
by keying in DTMF dial signals. For this the terminal has to be switched to DTMF
mode (Transparent Mode). This is done with a long-click of the *-key or with the
Foxkey.
The system phones automatically switch over to DTMF mode as standard once a
connection has been set up. This setting can be altered for each phone using the
Foxkey or via AMS.
To Next Page
Loading...
Need help?
General
