Features
359
System functions and features as of R3.0
syd-0367/1.3 – R3.0 – 03.2013
9. 2. 5 Features in the up-circuit communication server
A number of features can be triggered in the up-circuit communication server us-
ing route selection. For more details please refer to the user's guides of the termi-
nals and the features overview of the up-circuit communication server.
9. 2. 6 Features operated via QSIG
In private QSIG networks a number of features can be operated on third-party
PINXs via QSIG (applies only to Aastra 400 or Aastra IntelliGate systems). In such
cases it is irrelevant whether the QSIG networking is effected via a basic rate access
or a primary rate access and which QSIG variant is selected as the protocol. The ex-
ecuting user obtains (visual) confirmation as to whether or not the feature was suc-
cessfully carried out.
9. 2. 6. 1 User-unrelated features
User-unrelated features are operated via abbreviated dialling numbers defined on
the destination PINX and containing the corresponding function codes. These ab-
breviated dialling numbers are entered on one’s own PBX as PISN users in the num-
bering plan.
Note:
Make sure that these abbreviated dialling numbers are barred in the digit
barring on all PINXs for unauthorized users and that no names are assigned
to the abbreviated dialling numbers (bypassing the digit barring).
The following features are supported:
Tab. 147 User-unrelated QSIG features
Feature Activate Deactivate
Operate s
witch groups
*85<Swith group><Pos.>
Actuate door opener *74 <No. of the door intercom system>
Switch control output *74 <Call number
1)
>
1)
call number assigned to this control output in the numbering plan
#74 <Call number
1)
>
Enable/bar a one-off remote access *754 #754
Answer coded ringing on general bell *82
Answer ring call on general bell *83
Dial door intercom 851,852 (default values)
2)
2)
Only with Aastra 415/430 and if the corresponding number of ODAB card(s) is fitted
To Next Page
Loading...
Need help?
General
