Call routing
233
System functions and features as of R3.0
syd-0367/1.3 – R3.0 – 03.2013
6. 6. 5 Conversion and Routing (Network Provider Table)
The phone numbers are converted specifically for each network provider based on
the network provider table; the call routing is then determined. 20 network provid-
ers can be entered in the table.
Tab. 67 Network operator table
Settings of the network provider table:
• Access code:
Used for indirect access to a network provider. For direct access to a network
provider, indicating a route is sufficient.
Maximum access code length: 12 digits.
•Barring:
Enable or bar call routing to the corresponding network provider.
•User-ID / PIN:
syntax and length depend on the network operator.
• Call charge code length (single digit: <1..5>):
reduces the call charge code called up in the conversion rules to the specified
length, starting from the end. Example:
– In the conversion rule the user number is called up as a call charge code.
– The call charge code length is set to "3".
– User number 3426 is transmitted as call charge code 426.
Network Pro-
vider
Access
code
Route Barring
Conversion
rule
User ID PIN
Charge code
length
Network
provider 1
0512 – unas-
signed
EUKSN 4321 1234 3
Network pro-
vider 2
– 2 unavaila-
ble
–
Network pro-
vider 3
–3unas-
signed
To Next Page
Loading...
Need help?
General
