Numbering plan
62
System functions and features as of R3.0
syd-0367/1.3 – R3.0 – 03.2013
Note:
In the case of an external call to an integrated mobile phone the caller’s
CLIP is always transmitted to the mobile phone as redirecting informa-
tion. This also applies to external calls to a user who has redirected to an
integrated mobile phone. In this case the parameter Send redirecting
information must be set on Ye s in the trunk group settings and "Special
Arrangement" must be activated by the network provider.
Tip:
The mobile phone integration described above is not limited to mobile
phones; it can be used in principle for any external users.
See also:
A separate User’s Guide is available for the mobile phones on Aastra 400.
It includes an overview of the functions that can be carried out using
mobile phones.
3. 2. 5. 3 Aastra Mobile Client (AMC)
The Aastra Mobile Client is an application for the most common mobile phones
with open operating systems. It means that the main telephony functions are avail-
able through menu prompting.
One AMC Extension licence is required for each Aastra Mobile Client. This licence
also includes the Mobile Phone Extension. licence.
To set up an Aastra Mobile Client, proceed as follows:
1. Purchase a AMC Extension licence and enter the licence code in AMS. In addition
to the licence code an Aastra Mobile Client access code is also printed out. You
Enhanced function for directly
incoming calls
<Yes / No> • Trunk group setting: Allows the use of features of
integration level 2 if mobile phone integration is
made with separate lines to the provider
(depends on the provider).
MWI route <Route number> • Route for MWI signalling (new voice mail voice
message) to the integrated mobile phone.
MWI CLIP <CLIP No.> • The CLIP for MWI signalling (new voice mail voice
message) to the integrated mobile phone is
entered here. (input format the same as an exter-
nal call number e. g. 00326553827). The CLIP is
transmitted in accordance with the Transit CLIP
format parameter for trunk group settings.
Parameter Parameter value Remarks
To Next Page
Loading...
