Aastra 400 Series - Page 561

Features
561
System functions and features as of R3.0
syd-0367/1.3 – R3.0 – 03.2013
Function Redkey
On each system phone one or more function keys can be configured as Redkeys.
Depending on the application an alarm can then be triggered, a heating system
switched on, a process controlled, etc., with the aid of the ATAS protocol on an ATAS
server. The message sent contains the user number and additional parameters
(max. 32 characters/digits).
• The configuration is set for each phone and can only be made via AMS.
• The function can be stored on any configurable keys of the system phones.
• Several keys on each phone can be configured as Redkeys.
• The Redkey function can be triggered regardless of the operating state (idle, di-
alling, call, ringing) of the system phone.
• If the Redkey is configured on a function key, a distinction can be made between
single and double click due to a different assignment of the number memories.
• Once a Redkey has been configured, it can only be reconfigured via AMS.
• The application on the ATAS server can acknowledge that a function has been
triggered by a Redkey by sending a message to the phone’s display (with or
without a prompt to acknowledge the message).
Redkey as function code
To be able to perform the Redkey function also on third-party terminals (analogue
terminals, SIP terminals etc.), a */# function code is available. Possible applications
are analogue terminals in retirement homes, door intercom systems, lift telephones
etc.
Tab. 377 Trigger Redkey function: Function
Function Function code Note
Trigger Redkey function *73 <Parameter> # The parameter can contain a maxi-
mum of 28 digits.