Aastra 400 Series

To Next Page

To Previous Page

Features

563

System functions and features as of R3.0

syd-0367/1.3 – R3.0 – 03.2013

• Automatic trigger using man-down alarm: Man-down alarm

• Automatic trigger using no-movement alarm: No-movement alarm

• Combined automatic trigger using man-down and no-movement alarm

• Aastra 630d only: Automatic trigger using escape alarm: Escape alarm

This means the alarm server is able to respond differently to the alarms it receives,

depending on the type of trigger.

This functionality (as well as other features such as DECT locating) is available only

with the ATASpro protocol. The ATAS Interface and ATASpro Interface licences are

also required.

The hotkey on the side of the phone can be freely configured with phone number

and/or functions and is completely independent of the other alarm triggering

functions. It can also be configured as 1 hotkey only. The Redkey function can also

be stored on this key, which then generates other ATAS messages.

The following also applies for Aastra 630d:

• The alarm server is capable of alarming via the phone using 9 melodies. Of

these, one melody is Pager call and one Vibra call.

• The alarm server is capable of overriding the locally set alarm melodies. This also

applies to Vibra call and Tone ringing suppressed.

• The alarm server can use a special call alert to disconnect a call in progress and

raise the alarm using a rising default alarm tone.

• The alarm server can give the alarm a hidden function which is triggered when

the recipient of the alarm presses the Hook key (e. g. call to a number or setting

up a conference).

Note:

The phone acts as an alarm phone and is therefore only one component

within an entire alarm concept. The response to a triggered alarm

depends on the configuration and design of the alarm concept, and the

alarm functions must always be configured within the context of the

overall alarm concept.

Aastra 400 Series - Page 563