Electrical
Troubleshooting Guide
IRB6400 M94A
Appendix A - 70
Error Messages
71008: Phys. value out of range....................Chapter 11
DescriptionReason: Signal %s: Physical Max is less or equal than Physical Min. Check:
1. Correct the values to be max greater than min
71009: Type invalid................................Chapter 11
DescriptionReason: Signal %s: the type of signal is invalid. Check:
1. Change the type
71010: Signal out of range.........................Chapter 11
DescriptionReason: Signal %s: the physical signal. Check:
1. Change the physical signal number
2. Change the length
71011: Driver not supported........................Chapter 11
DescriptionReason: The driver %s is not supported. Check:
1. Change the name of the driver
71012: Memory overflow.............................Chapter 11
DescriptionReason: Board %s: Too many boards for specified driver type. Check:
1. Change number of boards for the driver at driver configuration.
71013: Wrong type of board.........................Chapter 11
DescriptionReason: Wrong type of board connected to address %d. Check:
1. Check the board type at given address
71014: Board missing...............................Chapter 11
DescriptionReason: No board connected at given address %d. Check:
1. Connect a board to the slot
2. Change the board address
71015: Digital Input overflow......................Chapter 11
DescriptionReason: Number of digital input channels for board %s is greater than %d.
Check:
1. Reduce the number digital inputs
71016: Digital Output overflow.....................Chapter 11
DescriptionReason: Number of digital output channels for board %s is greater than %d.
Check:
1. Reduce the number of digital outputs
I/O & Communication Error Messages (Cont)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
