Chapter 5 97
Setting Measurement Conditions
Setting Number of Points (NOP)
5. Setting Measurement
Conditions
Setting Number of Points (NOP)
Step 1. Press [Sweep] to display the sweep menu.
Step 2. Press the
NUMBER OF POINTS key. This will display the current setting for number of
points in the parameter settings area in the upper-left part of the screen.
Step 3. Use keys or the rotary knob in the ENTRY block in one of the following ways to specify a
value for the number of points.
• Enter the desired value with the numeric keys (
[0] to [9]) and then press the [´1] key.
• Turn the rotary knob (
m
mm
m) until the desired value is set.
• Press the step keys ([][¯]) to set the desired value.
NOTE The number of sweep points can be set to any integer from 2 to 801.
When list is selected as a sweep type (list sweep), use a list sweep table to set the number
of points.
Setting the number of points is applied commonly to traces A and B.
Figure 5-12 Number of points: 51
To Next Page
Loading...
