Agilent Technologies 4294A - Softkeys Displayed by Pressing the [Copy] Key

Appendix B 417
Key Definitions
Softkeys displayed by pressing the [Copy] key
B. Key Definitions
Softkeys displayed by pressing the [Copy] key
Table B-98 Copy (Copy) menu
Key operation: [Copy]
Softkey Function GPIB command
START Starts printing the measurement graph displayed on the screen with the printer
connected to the printer parallel port on the rear panel. Note that the
measurement graph is not displayed on the screen if you have not selected the
ALL INSTUMENT key or the HALF INSTR HALF BASIC key in Table B-21,
“Display allocation (Disp Alloc) menu,” on page 369.
PRINALL
ABORT Aborts the printing operation. COPA
SETUP ä Displays Table B-99, “Copy configuration (Copy Setup) menu (1/2),” on page
417.
(N/A)
DEFAULT SETTING Resets the configurations changed with the above SETUP key to the initial
values (print resolution: 75 dpi, form feed: ON, form orientation: portrait,
softkey label print: OFF, top margin: 1.0 inch, left margin: 1.0 inch).
DFLT
SELECT CONTENTS ä Displays Table B-101, “Copy data selection (Copy Contents) menu,” on page
418.
(N/A)
Table B-99 Copy configuration (Copy Setup) menu (1/2)
Key operation: [Copy] - SETUP
Softkey Function GPIB command
B&W
|
Selects black-and-white printing. PRIC STAN
FIXED COLOR
|
Selects the print mode in which information on the screen is printed using preset
colors.
PRIC FIXE
IMAGE COLOR Selects the print mode in which colors as close as possible to those on the screen
are used
1
. You can change the colors on the screen in Table B-22, “Display color
modification (Modify Color) menu,” on page 370.
1. Print colors may differ from those displayed on the screen due to the ink used by your printer. The background in printing is
always set to white.
PRIC VARI
DPI Sets the resolution in DPI (dot/inch) of the printer used. You can specify the
resolution within a range of 75 - 600 dpi.
DPI <value>
TOP MARGIN Sets the margin at the top of printed forms in inches. You can specify the margin
within a range of 0 - 5 inches in steps of 0.1 inch.
TMARG <value>
LFT MARGIN Sets the margin at the left side of printed forms in inches. You can specify the
margin within a range of 0 - 5 inches in steps of 0.1 inch.
LMARG <value>
more 1/2 Displays Table B-100, “Copy configuration (Copy Setup) menu (2/2),” on page
418.
(N/A)
return Returns to Table B-98, “Copy (Copy) menu,” on page 417. (N/A)