356 A
Manual Changes
Manual Changes
To adapt this manual to your 4294A, refer to Table A-1 and Table A-2.
Agilent Technologies uses a two-part, ten-character serial number that is stamped on the
serial number plate (see Figure A-1). The first five characters are the serial prefix and the
last five digits are the suffix.
Press
[System] - DIAGNOSTIC TEST - FIRMWARE REVISION keys to display the
firmware version of your Agilent 4294A.
Figure A-1 Example of Serial Number Plate
Table A-1 Manual Changes by Serial Number
Serial Prefix or Number Make Manual Changes
Table A-2 Manual Changes by Firmware Version
Version Make Manual Changes
1.10
To Next Page
Loading...
