Agilent Technologies 4294A - Selecting the Phase Unit

Chapter 7 197
Setting Up the Display of Measurement Results
Selecting the Phase Unit
7. Setting Up the Display of
Measurement Results
Selecting the Phase Unit
When you are performing phase-based measurement, you can specify whether to use
degrees or radian as the phase unit applied to the scaling and marker features.
Step 1. Activate the trace for which you want to set the phase unit.
NOTE To set the phase unit, your parameter must be either |Z|-q / |Y|-q or COMPLEX Z-Y. You
should activate Trace B in the former case, and the trace whose axis format is polar in the
latter case.
Step 2. Press the
[Format] key to display the Format menu.
Step 3. Press the PHASE UNIT [ ] key to select your desired phase unit (pressing the key toggles
your selection).
To activate: Press:
Trace A
[A]
Trace B [B]
Softkey Labels Phase unit
PHASE UNIT [DEG] Degrees (°)
PHASE UNIT [RAD] Radian