Chapter 5 105
Setting Measurement Conditions
Setting Oscillator Level
5. Setting Measurement
Conditions
Setting Oscillator Level
Follow the steps below to specify a fixed oscillator level (AC level) when the sweep
parameter is any item other than oscillator level (i.e., frequency or dc bias).
Step 1. Press the
[Source] key to display the signal source menu.
Step 2. Press the
LEVEL key. This will display the current setting for the fixed oscillator level for
the segment in the parameter settings area in the upper-left part of the screen.
Step 3. Use the keys or the rotary knob in the ENTRY block in one of the following ways to
specify a value for the fixed oscillator level.
• Enter the desired value with the numeric keys (
[0] to [9], [.], and [-]) and then press one
of the unit keys (
[G/n], [M/m], [k/m], or [´1]).
• Turn the rotary knob (
m
mm
m) until the desired value is set.
• Press the step keys ([][¯]) to set the desired value.
NOTE See “Selecting Unit for Oscillator Level (Voltage or Current)” on page 106 for selecting
unit (voltage or current) of the fixed oscillator level.
To Next Page
Loading...
Need help?
General
