A 357
Manual Changes
Change to the revision 1.0x
A. Manual Changes
Change 1
The firmware before the revision 1.0x does not support the following function.
• Saving the internal data in the touchstone format.
Change to the revision 1.0x
Chapter 8 , “Analysis and Processing of Result,” on page 211
Delete the following section
• “Saving a data array in touchstone format” on page 285
• “Using a file saved in touchstone format” on page 286
Table B-105 on page 421
Modify as follows.
Key operation: [Save]
Softkey Function GPIB command
STATE ä Selects storage of the configuration states and internal data array of the Agilent
4294A and displays Table B-106, “Filename entry (File Name) menu,” on page
421.
SAVDSTA <string>
DATA ä Selects storage of the internal data array of the Agilent 4294A and displays Table
B-107, “Data save (Save Data) menu,” on page 422.
(N/A)
GRAPHICS ä Selects storage of the displayed screen in TIFF format and displays Table B-106,
“Filename entry (File Name) menu,” on page 421. It is stored in the colors
selected in Table B-99, “Copy configuration (Copy Setup) menu (1/2),” on page
417. The softkeys are also stored.
SAVDTIF <string>
RE-SAVE FILE ä Displays Table B-111, “File selection (Select File) menu,” on page 424. RESAVD <string>
POWER ON CONFIG ä Displays Table B-109, “Power-on configuration save (Save config?) menu,” on
page 423.
SAVPSTA
FILE UTILITIES ä Displays Table B-110, “File utility (File Utility) menu,” on page 423. (N/A)
STORE DEV [ ] ä Displays Table B-81, “Mass storage (Store Device) menu,” on page 408. In [ ]
of the softkey label, the currently selected mass storage is displayed (flexible
disk drive: [FLOPPY], volatile memory disk: [MEMORY], or nonvolatile
memory disk (flash memory): [FLASH]).
(N/A)
To Next Page
Loading...
Need help?
General
