304 Chapter 9
Setting/Using Control and Management Functions
Setting the Built-in Speaker (Beep Sound)
Setting the Built-in Speaker (Beep Sound)
The Agilent 4294A has a built-in speaker to output beep sounds. The beep sound functions
are classified into the following three groups. You can set each of them on or off.
Follow the steps below to turn on/off the completion beep and warning beep. For how to
turn on/off the limit line test fail beep, refer to Step 4 in “Conduct the limit line test” on
page 262.
Turning On/Off the Completion Beep
Follow these steps to turn on and off the completion beep.
Step 1. Press the
[System] key to display the System menu.
Step 2. Press the
BEEPER key to display the Built-In Speaker menu.
Step 3. Press the BEEP DONE on OFF key (BEEP DONE ON off key) to turn on/off the
completion beep (pressing the key toggles your selection).
Turning On/Off the Warning Beep
Follow these steps to turn on and off the warning beep.
Step 1. Press the
[System] key to display the System menu.
Step 2. Press the
BEEPER key to display the Built-In Speaker menu.
Step 3. Press the
BEEP WARN on OFF key (BEEP WARN ON off key) to turn on/off the warning
beep (pressing the key toggles your selection).
Table 9-1 Beep functions of the Agilent 4294A
Type Function
Completion beep Sounds when storage of calibration or instrument states
is completed.
Warning beep Sounds when a warning message occurs.
Limit line test fail beep Sounds when the result of a limit line test is fail.
Softkey label Setting of the completion beep
BEEP DONE ON off On
BEEP DONE on OFF Off
Softkey label Setting of the warning beep
BEEP WARN ON off On
BEEP WARN on OFF Off
To Next Page
Loading...
Need help?
General
