Chapter 7 199
Setting Up the Display of Measurement Results
Hiding the Non-active Trace
7. Setting Up the Display of
Measurement Results
Hiding the Non-active Trace
When the screen is not split into upper and lower halves (see “Splitting the Graph” on
page 200), Traces A and B appear on the same graph and may overlap each other, making
it difficult to examine the DUT’s characteristics. In this case, you can optionally hide the
non-active trace.
Step 1. Press the
[Display] key to display the Display menu.
Step 2. Press the
HIDE INACT on OFF (or HIDE INACT ON off) key to hide or show the non-active
trace (pressing the key toggles your selection).
NOTE Once you have specified whether to hide or show the non-active trace, that setting is
applied to both Traces A and B. You can specify this setting without activating one of the
traces or checking the current state.
When the screen is split into upper and lower halves (see “Splitting the Graph” on page
200), you cannot hide the non-active trace.
Softkey Labels Description
HIDE INACT ON off Indicates that the non-active trace is hidden.
HIDE INACT on OFF Indicates that the non-active trace is shown
along with the active trace.
To Next Page
Loading...
Need help?
General
