82 Chapter 5
Setting Measurement Conditions
Putting the Agilent 4294A into the Preset State (Presetting)
Putting the Agilent 4294A into the Preset State (Presetting)
Step 1. Press the [Preset] key.
Executing presetting will put the Agilent 4294A into an initial state called the “preset
state.”
When turning on the power to the Agilent
4294A, a power-on state file is loaded to restore
the setting stored in the file if it has been saved in the mass storage of the Agilent
4294A.
We recommend that you to perform presetting by pressing the
[Preset] key each time you
put the Agilent 4294A into a new setting, regardless of whether it is done immediately after
turning the power on.
Note that the adapter setting is not affected by initialization with the
[Preset] key; once it is
set, it cannot be modified by pressing the [Preset] key.
To Next Page
Loading...
Need help?
General
