Chapter 10 345
Specifications and Supplemental Performance Characteristics
Basic Characteristics
10. Specifications and
Supplemental Performance
Characteristics
Equivalent Circuit Analysis
Limit Line Test
Mass Storage
Parallel Printer Port
Circuit models 3-component model (4 models), 4-component model
(1 model)
Analysis types Equivalent circuit parameters calculation, frequency
characteristics simulation
Available setup parameters for
each segment
Sweep start value, sweep stop value, upper limit
(middle value) and lower limit (delta limit) for sweep
start, upper limit (middle value) and lower limit (delta
limit) for sweep stop
Number of segments 1 to 18
Other functions Beep fail, limit line offset
Flexible disk drive
Type 3.5 inch, Built-in
Size 1.44 MB
Format DOS
Formatting Available
Volatile memory disk
Size 512 KB
Nonvolatile memory disk
(flash memory)
Size 10 MB
Stored data State (binary), data (binary or ASCII), display
graphics (TIFF)
Interface standard IEEE 1284 Centronics
Printer control language HP PCL3 printer control language
Connector type 25-pin D-SUB connector
To Next Page
Loading...
Need help?
General
