Chapter 5 103
Setting Measurement Conditions
Setting Time Delay for Measurement
5. Setting Measurement
Conditions
Setting with sweep time delay
Time delay can be set at the point before sweep starts.
Step 1. Press the [Sweep] key to display the sweep menu.
Step 2. Press the
TIME key to display the sweep time menu.
Step 3. Press the
SWEEP DELAY key. This will display the current setting for the sweep time
delay in the parameter settings area in the upper-left part of the screen.
Step 4. Use the keys or the rotary knob in the ENTRY block in one of the following ways to
specify a value for the sweep time delay.
• Enter the desired value with the numeric keys (
[0] to [9], [.], and [-]) and then press one
of the unit keys (
[G/n], [M/m], [k/m], or [´1]).
• Turn the rotary knob (
m
mm
m) until the desired value is set.
• Press the step keys ([][¯]) to set the desired value.
To Next Page
Loading...
