Chapter 7 201
Setting Up the Display of Measurement Results
Splitting the Graph
7. Setting Up the Display of
Measurement Results
Figure 7-30 Traces A and B with split display enabled
NOTE Before you can turn on or off the split display feature, you must configure the screen
assignments for HP Instrument BASIC by pressing the
ALL INSTRUMENT or
BASIC STATUS key. For more information, refer to “Configuring the Screen Assignments
for HP Instrument BASIC” on page 202.
Once you have turned on or off the split display feature, that setting is applied to both
Traces A and B. You can specify this setting without activating one of the traces or
checking the current state.
To Next Page
Loading...
Need help?
General
