Chapter 8 255
Analysis and Processing of Result
Calculating the mean value, standard deviation, and peak-to-peak of the
trace
8. Analysis and Processing
of Result
Figure 8-22 Statistics display of trace
NOTE Each time a single sweep is completed, the statistics are calculated and the display is
updated.
In Figure 8-22 on page 255, the trace statistics display function is used to obtain the
peak-to-peak value (difference between the minimum value and the maximum value). On
the other hand, in Figure 8-4 on page 220, the delta marker function is used to obtain the
same parameter.
To Next Page
Loading...
