Agilent Technologies 4294A - Page 430

422 Appendix B
Key Definitions
Softkeys displayed by pressing the [Save] key
done Using the entered string as the filename, executes storing states, data, or
graphics. When creating a directory, a directory having the entered string is
created. After execution, returns to the higher-level menu (Table B-105, “Save
(Save) menu,” on page 421, Table B-107, “Data save (Save Data) menu,” on
page 422, or Table B-110, “File utility (File Utility) menu,” on page 423).
(N/A)
cancel Cancels the storage or creation of a directory and returns to the higher-level
menu (Table B-105, “Save (Save) menu,” on page 421, Table B-107, “Data save
(Save Data) menu,” on page 422, or Table B-110, “File utility (File Utility)
menu,” on page 423).
(N/A)
Table B-107 Data save (Save Data) menu
Key operation: [Save] - DATA
Softkey Function GPIB command
BINARY ä Selects storage of measured data in binary format and displays Table B-106,
“Filename entry (File Name) menu,” on page 421.
SAVDDAT <string>
ASCII ä Selects storage of measured data in ASCII format and displays Table B-106,
“Filename entry (File Name) menu,” on page 421.
SAVDASC <string>
SELECT CONTENTS ä Displays Table B-108, “Data save item selection (Save Contents) menu,” on
page 422.
(N/A)
STORE DEV [ ] ä Displays Table B-81, “Mass storage (Store Device) menu,” on page 408. In [ ]
of the softkey label, the currently selected mass storage is displayed (flexible
disk drive: [FLOPPY], volatile memory disk: [MEMORY], or nonvolatile
memory disk (flash memory): [FLASH]).
(N/A)
return Returns to Table B-105, “Save (Save) menu,” on page 421. (N/A)
Table B-108 Data save item selection (Save Contents) menu
Key operation: [Save] - DATA - SELECT CONTENTS
Softkey Function GPIB command
CAL on OFF Toggles on (stores) and off (does not store) storage of the calibration coefficient
array.
SAVCAL {ON|OFF}
DATA on OFF Toggles on (stores) and off (does not store) storage of the data array. SAVDAT {ON|OFF}
MEMORY on OFF Toggles on (stores) and off (does not store) storage of the memory array. SAVMEM {ON|OFF}
TRACE DATA ON off Toggles on (stores) and off (does not store) storage of the trace array. SAVDTRC {ON|OFF}
TRACE MEM ON off Toggles on (stores) and off (does not store) storage of the memory trace array. SAVMTRC {ON|OFF}
return Returns to Table B-107, “Data save (Save Data) menu,” on page 422. (N/A)
Table B-106 Filename entry (File Name) menu
Key operation: [Save] - STATE
[Save] - DATA - BINARY/ASCII
[Save] - GRAPHICS
[Save] - FILE UTILITIES - CREATE DIRECTORY
Softkey Function GPIB command