Agilent Technologies n5181a - Page 200

184 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
SCPI Compatibility
E44xxB Compatible Commands
[:SOURce]:RADio:ARB:MARKer:CLEar:ALL "<file
name>",<mkr(1|2)>
✓
[:SOURce]:RADio:ARB:MARKer:POLarity
NEGative|POSitive
[:SOURce]:RADio:ARB:MARKer:POLarity?
✓
[:SOURce]:RADio:ARB:MARKer:RFBLank ON|OFF|1|0
[:SOURce]:RADio:ARB:MARKer:RFBLank?
✓
[:SOURce]:RADio:ARB:MARKer[:SET] "<file
name>",<mkr(1|2)>,<first_Point>,
<last_point>,<skip_count>
✓
[:SOURce]:RADio:ARB:RETRigger 1|0 ✓ This command is not recommended; the
following command is the preferred syntax for
the ESG E44xxB.
[:SOURce]:RADio:ARB:RETRigger ON|OFF
[:SOURce]:RADio:ARB:RETRigger?
✓ This query for the Agilent MXG Vector Signal
Generator (N5182A) only returns the string ON
or OFF. This is different from the ESG E44xxB
query which returns a 1 or 0.
[:SOURce]:RADio:ARB:RFILter <value>|THRough ✓ This command performs no function within
the Agilent MXG Vector Signal Generator
(N5182A), however it is accepted when
executed without errors. Notice that the query
form of the command is not compatible.
[:SOURce]:RADio:ARB:RFILter? –
[:SOURce]:RADio:ARB:SCALing "<file
name>",<1%–100%>
✓
[:SOURce]:RADio:ARB:SEQuence "<file
name>","<waveform>",<reps>,<mkr1(1|0)>,
<mkr2(1|0)>{,"<waveform>",<rep>,<mkr1(1|0)>,<m
kr2(1|0)>}
[:SOURce]:RADio:ARB:SEQuence? "<file name>"
✓
[:SOURce]:RADio:ARB:TRIGger:TYPE
CONTinuous|SINGle|GATE|SADVance
[:SOURce]:RADio:ARB:TRIGger:TYPE?
✓
Table 6-1 E44xxB Program Codes and Equivalent SCPI Sequences
3 = Supported by Agilent MXG
– = Not supported by Agilent MXG
E44xxB
Remarks