Agilent Technologies n5181a - Page 201

Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 185
SCPI Compatibility
E44xxB Compatible Commands
[:SOURce]:RADio:ARB:TRIGger:TYPE:GATE:ACTive
LOW|HIGH
[:SOURce]:RADio:ARB:TRIGger:TYPE:GATE:ACTive?
✓
[:SOURce]:RADio:ARB:TRIGger[:SOURce]
KEY|EXT|BUS
[:SOURce]:RADio:ARB:TRIGger[:SOURce]?
✓
[:SOURce]:RADio:ARB:TRIGger[:SOURce]:EXTernal:
DELay <value>
[:SOURce]:RADio:ARB:TRIGger[:SOURce]:EXTernal:
DELay?
✓
[:SOURce]:RADio:ARB:TRIGger[:SOURce]:EXTernal:
DELay:STATe ON|OFF|1|0
[:SOURce]:RADio:ARB:TRIGger[:SOURce]:EXTernal:
DELay:STATe?
✓
[:SOURce]:RADio:ARB:TRIGger[:SOURce]:EXTernal:
SLOPe POSitive|NEGative
[:SOURce]:RADio:ARB:TRIGger[:SOURce]:EXTernal:
SLOPe?
✓
[:SOURce]:RADio:ARB:WAVeform "<file name>"
[:SOURce]:RADio:ARB:WAVeform?
✓
[:SOURce]:RADio:ARB[:STATe] ON|OFF|1|0
[:SOURce]:RADio:ARB[:STATe]?
✓
Edge Subsystem
[:SOURce]:RADio:EDGE:... – This subsystem is not supported.
GSM Subsystem
[:SOURce]:RADio:GSM:... – This subsystem is not supported.
Input Subsystem
:INPut:BERT[:BASeband]:... – This subsystem is not supported.
Measure Subsystem
:MEASure... – This subsystem is not supported.
Multi- Tone Subsystem
Table 6-1 E44xxB Program Codes and Equivalent SCPI Sequences
3 = Supported by Agilent MXG
– = Not supported by Agilent MXG
E44xxB
Remarks