Agilent Technologies n5181a - Page 214

198 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
SCPI Compatibility
E4428C/38C Compatible Commands
:SYSTem:HELP:MODE SINGle ✓ Supported but the following parameter is not
supported: CONTinuous
Supported but the following query is not
supported:
:SYSTem:HELP:MODE?
:SYSTem:LANGuage "SCPI"|"COMP"|"8648"
:SYSTem:LANGuage?
✓ Supported but the following parameters are
not supported:
"8340"|"8360"|"83712"|"83732"|"83752"|"
8757"|"8662"|"8663"|”NADC”|”PDC”|”PHS”
:SYSTem:PON:TYPE PRESet|LAST
:SYSTem:PON:TYPE?
✓
:SYSTem:PRESet ✓ Always performs the same action as the Preset
hardkey.
For related Preset hardkey information, refer to
“:SYSTem:PRESet:TYPE NORMal|USER
:SYSTem:PRESet:TYPE?” on page 198
:SYSTem:PRESet:ALL ✓
:SYSTem:PRESet:LANGuage "SCPI"|"COMP"|"8648"
:SYSTem:PRESet:LANGuage?
✓ Supported but the following parameters are
not supported:
"8340"|"8360"|"83712"|"83732"|"83752"|"
8757"|"8662"|"8663"|”NADC”|”PDC”|”PHS”
:SYSTem:PRESet:PERSistent ✓
:SYSTem:PRESet:TYPE NORMal|USER
:SYSTem:PRESet:TYPE?
✓ This command toggles the Preset hardkey state
between factory- and user- defined conditions.
The setting enabled by this command is not
affected by signal generator power- on, preset,
or *RST.
NOTE If the Preset hardkey is not
responding correctly, using the SCPI
command: :SYSTem:PRESet:TYPE
NORMal will return the Preset
hardkey to its default factory
behavior.
Table 6-2 E4428C/38C Program Codes and Equivalent SCPI Sequences
3 = Supported by Agilent MXG
– = Not supported by Agilent MXG
N51xxA
Remarks