Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 211
SCPI Compatibility
E4428C/38C Compatible Commands
[:SOURce]:POWer:ALC[:STATe] ON|OFF|1|0
[:SOURce]:POWer:ALC[:STATe]?
✓
[:SOURce]:POWer:ALTernate:AMPLitude <value>dB
[:SOURce]:POWer:ALTernate:AMPLitude?
–
[:SOURce]:POWer:ALTernate:MANual MAIN|DELTa
[:SOURce]:POWer:ALTernate:MANual?
–
[:SOURce]:POWer:ALTernate:STATe ON|OFF|1|0
[:SOURce]:POWer:ALTernate:STATe?
–
[:SOURce]:POWer:ALTernate:TRIGger[:SOURce]
INTernal|EXTernal|MANual
[:SOURce]:POWer:ALTernate:TRIGger[:SOURce]?
–
[:SOURce]:POWer:ATTenuation <value><unit>
[:SOURce]:POWer:ATTenuation?
✓
[:SOURce]:POWer:ATTenuation:AUTO ON|OFF|1|0
[:SOURce]:POWer:ATTenuation:AUTO?
✓
[:SOURce]:POWer:MODE FIXed|LIST|SWEep
[:SOURce]:POWer:MODE?
✓
[:SOURce]:POWer:PROTection[:STATe] ON|OFF|1|0
[:SOURce]:POWer:PROTection[:STATe]?
✓
[:SOURce]:POWer:REFerence <value><unit>
[:SOURce]:POWer:REFerence?
✓
[:SOURce]:POWer:REFerence:STATe ON|OFF|1|0
[:SOURce]:POWer:REFerence:STATe?
✓
[:SOURce]:POWer:STARt <value><unit>
[:SOURce]:POWer:STARt?
✓
[:SOURce]:POWer:STOP <value><unit>
[:SOURce]:POWer:STOP?
✓
Table 6-2 E4428C/38C Program Codes and Equivalent SCPI Sequences
3 = Supported by Agilent MXG
– = Not supported by Agilent MXG
N51xxA
Remarks
To Next Page
Loading...
