238 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
SCPI Compatibility
8656B, 8657A/B/D/J Programming Codes
MZ Unit used with the
frequency command
MHz
P0
c
Digital Modulation Off The Agilent MXG does not support this feature.
P4
c
Digital Modulation On The Agilent MXG does not support this feature.
PC
d
Unit used with the
modulation command
PCT
PD Phase Decrement [:SOURce]:PHASE[:ADJust] <value><RAD>
PF Pulse Modulation (Fast
Mode)
Refer to, “PF (Pulse Modulation- Fast Mode) or PM (Pulse
Modulation)” on page 240.
PI Phase Increment [:SOURce]:PHASE[:ADJust] <value><RAD>
PM Pulse Modulation [:SOURce]:PULM:SOURce EXT2
[:SOURce]:PULM:STATe ON
QS Reverse Sequence *RCL <reg>
RC Recall (0−9) *RCL <reg>
RL Recall (0−99) *RCL <reg>
RP
e
Reverse Power Protection
Reset
No equivalent SCPI command
R2 RF Off OUTPut[:STATe] OFF
R3 RF On OUTPut[:STATe] ON
R5 RF Dead (Full Attenuator) OUTPut[:STATe] OFF
SQ Sequence *RCL <reg>
ST Save (0−9) *SAV <reg>
SV Save (0−99) *RCL <reg>
S1 External Modulation Source Refer to, “S1, S2, or S3 used with AM” on page 240 or “S1,
S2, or S3 used with FM” on page 241.
S2 Internal 400 Hz Modulation
Source
Refer to, “S1, S2, or S3 used with AM” on page 240 or “S1,
S2, or S3 used with FM” on page 241.
S3 Internal 1 kHz Modulation
Source
Refer to, “S1, S2, or S3 used with AM” on page 240 or “S1,
S2, or S3 used with FM” on page 241.
8656B,
8657A/B/D/J
Codes
a
Description Equivalent SCPI Command Syntax
To Next Page
Loading...
