File
4
IMPLEMENTING MOBILE REFLEXES
HANDSETS
CALL SERVER : MOBILITY
Ed. 04 7/10Réf. 3EH 21000 BSAA
Description of radio test mode functions
STATE / RSSI (state / reception level)
Mobile transmission status
L: mobile synchronized with system (no communication established)
C: DECT link active between base station and mobile (in communication)
L F:3 S:3 B:11 0
RSSI->017/11H:-49
M:0 ->051/33H:-59
Frequency (0 to 9) used for transmission
In the example: frequency number = 3.
Identifier of the base station on which the mobile is synchronized
(RPN number). In the example: RPN = 11.
Time interval (0 to 11) used for transmission (displayed as 0 to B
in hexadecimal)
(In the example: time interval number = 3.
0 = mobile free to perform handovers between all system base stations
1 = mobile restricted to using a single base station (no handover)
Reception level (in -dBm) of the 2 base stations that the mobile picks up
best. In the example, base 11 is received at -49 dBm and base 33 at
-59 dBm. There are two display modes:
- rapid measurement (over 16 frames)
- average measurement (over 256 frames)
You can switch between measurement modes with a long press on *.
NB: the max. RSSI level displayed is around -42 dBm
(beyond this threshold the figures are insufficiently accurate).
1 = average measurement
0 = rapid measurement
You can switch between measurement modes with a long press on *.