INSTALLATION - CONFIGURATION CALL SERVER : VOICE ON IP
Ed. 042/20 Réf. 3EH 21000 BSAA
INSTALLING THE VoIP CoCPU BOARD
You can install up to 6 VoIP CoCPU boards (2 per unit) connected to a given Ethernet LAN via RJ45
connectors. Each board has its own IP address.
If several boards are installed, one of them is the "master" board: its IP address and software charac-
teristics serve as a reference. The other VoIP CoCPU boards are known as "slaves".
Default IP addresses
- Master VoIP CoCPU: 192.168.92.248
- Slave VoIP CoCPU: 192.168.92.249 to 192.168.92.253
Nota : Whatever the configuration, there is at least one master board and up to 5 slave boards:
The CoCPU boards can only be inserted when the system is powered down.
General software configuration
The general configuration defines the minimum parameters to be set regardless of the VoIP service to
be implemented:
- H.323 gateway only.
- IP telephony only.
- H.323 gateway and IP telephony.
VoIP CoCPU board
General network parameter settings
- Hostname: DNS name or alias of the board (optional parameter).
- IP Address: IP address of the board.
- IP Subnet Mask: subnet mask of the board.
- Master/Slave: (read-only parameter) the master / slave role of the CoCPU boards is determined
by their order of appearance in the PBX.
Configuring the parameters of a CoCPU board using PM5
- You can enter the IP addresses of the VoIP CoCPU boards together with their DNS name.
- Indication of subnet mask common to all the VoIP CoCPU boards.
- by MMC-PM5 (Expert View): Hardware and Limits -> IP Boards
To Next Page
Loading...
Need help?
General