INTERNET ACCESS E-SERVER : INTERNET APPLICATIONS
Ed. 044/14 Réf. 3EH 21000 BSAA
This information is provided by the IAP for a connection using a DSL modem. In this case, a point
to point connection is established between OmniPCX Office and the DSL model. Two types of com-
munication protocols are available to manage this connection.
• PPPoE: this protocol is used to send PPP packets over Ethernet. This protocol allows "permanent"
or "on-demand call" type connections.
- PPTP: This protocol consists of establishing an IP tunnel between Alcatel OmniPCX Office and
the modem. This protocol allows only “permanent” connections.
- Connection properties
To define the connection parameters, the IAP gives the following elements:
• “DSL modem address” or “Router address”: this is the IP address of the router or of the DSL
modem.
• “Network mask”: parameter determining the range of the network.
- “System IP address”: this is the IP address of the WAN interface. These parameters must be con-
sistent with the IP address of the router or of the DSL modem.
Instllation procedure
1. Connect the CPU card using an Ethernet cable:
• either to an RJ45 jack available on the company's LAN.
- or to the internal switch in the Alcatel OmniPCX Office cabinet. This switch can then be connec-
ted to another switch if Alcatel OmniPCX Office has several switches.
To Next Page
Loading...
