Alcatel OmniPCX Office Technical Documentation

INSTALLATION PROCEDURES PM5 : SYSTEM CONFIGURATION
Ed. 046/10 Réf. 3EH 21000 BSAA
LOCAL V24 ACCESS FOR PM5
It is possible to use PM5 software to dialog with OmniPCX Office using a V24 connection.
In this case the network connection is not necessary.
A specific cable has to be connected between the "Config" RJ45 connector on the system CPU to the
Port Com of the PC using PM5.
Wiring of the connection cable:
Installation procedure
-Open PM5 software on the PC.
- Select the Expert mode.
-Click on Comm menu.
- Select Connect menu.
- select Local menu
- The system proposes to install Alcatel OmniPCX Office direct V24
- click on Yes
- the system open the window Modem properties
- click on Add
- in Installation Window click on Next (put a cross in the box "do not detect the modem automati-
cally")
- select Alcatel in the manufacturers list
- select OmniPCX direct V24 for Windows NT or OmniPCX direct V24/W9xMe for Windows 95
or 98 and Millenium.
- select the Port Com used
- click on Next
- click on Finish
- click on Close
- back in PM5, click on Com
- the "local" box in now active and port Com is displayed
- click on Ok and enter the password
- wait for few seconds; the PM5 is now connected to the system.
RJ45 SUB D 9-point (F)
1
2
3
4
5
6
7
8
7
4
3
5
2
6
8

Alcatel OmniPCX Office Specifications

General

VoIP Support	Yes
SIP Support	Yes
ISDN Support	Yes
Analog Support	Yes
Integrated Voice Mail	Yes
Auto Attendant	Yes
Conferencing	Yes
VoIP Protocols	SIP, H.323
Power Supply	100-240 VAC, 50/60 Hz
Network Interfaces	10/100 Mbps Ethernet
Humidity	10% to 90% non-condensing