EasyManuals Logo

Alcatel OmniPCX Office Technical Documentation

Alcatel OmniPCX Office
964 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #810 background imageLoading...
Page #810 background image
CONFIGURATION OF STATIONS MMC STATION
Ed. 0414/18 Réf. 3EH 21000 BSAA
inactive (tp1).
- : by successively pressing this key, you can define whether the time-out 2 is active (TP2) or
inactive (tp2).
- or : by successively pressing on this key, you can define whether the system should route
the call to the operator and/or the general bell after the non-response time-out TP2 has lapsed
(active = ATTD or GBEL; inactive = attd or gbel).
- makes it possible to authorize (DIVE) or not (dive) forwarding for this key.
- makes it possible to define a destination station (or group) for the dynamic routing in the
case of no answer after a time-out TP1 (12 seconds by default).
o Type of call
This sub-function is only provided for the RGI, RGO and RGM keys.
makes it possible to determine the type of calls managed by the key concerned.
By successively pressing the key, you can choose between Ext/Loc, External and Local.
o Number of the associated station
This sub-function is only provided for the RSL, RSD and SUP keys. makes it possible to define the
directory number of the associated station.
DYNAMIC ROUTING OF CALLS - DYNROU
Dynamic routing of calls makes it impossible to have a call (internal, external, private, ...) remaining
unanswered.
Press .
and make it possible to define whether the dynamic distribution (time-outs T1 and T2, des-
tinations) criteria for each type of call (external or local) are active or not:
- makes it possible to define a destination station (or group) for the dynamic routing in the
case of no answer after a time-out TP1 (12 seconds by default).
- : by successively pressing this key, you can define whether the time-out 1 is active (TP1) or
inactive (tp1).
- : by successively pressing this key, you can define whether the time-out 2 is active (TP2) or
inactive (tp2).
- or : by successively pressing on this key, define whether the system should route the call
to the operator and/or the general bell after the non-response time-out TP2 has lapsed (active =
ATTD or GBEL; inactive = attd or gbel).
- makes it possible to authorize (DIVE) or not (dive) forwarding for this key.
and make it possible to define the time-outs in tenths of a second. The default value is 12
seconds.
TP2
OPERAT
GENBEL
DIVERT
N
U
MBER
CALTYP
CALTYP
N
U
MBER
A
DYNROU
A
EXTERN L
OC
AL
NUMBER
TP1
TP2
OPERAT
GENBEL
DIVERT
TM
OU
T1 TM
OU
T2

Table of Contents

Other manuals for Alcatel OmniPCX Office

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alcatel OmniPCX Office and is the answer not in the manual?

Alcatel OmniPCX Office Specifications

General IconGeneral
VoIP SupportYes
SIP SupportYes
ISDN SupportYes
Analog SupportYes
Integrated Voice MailYes
Auto AttendantYes
ConferencingYes
VoIP ProtocolsSIP, H.323
Power Supply100-240 VAC, 50/60 Hz
Network Interfaces10/100 Mbps Ethernet
Humidity10% to 90% non-condensing