Alcatel OmniPCX Office Technical Documentation

File
9
GROUPSMMC STATION
Ed. 04 3/4Réf. 3EH 21000 BSAA
BROADCAST GROUPS - BROADC
After pressing , enter the broadcast group directory number. The directory number of the first
station in the group is displayed.
makes it possible to add a station directory number to the group. Enter the number of the station
to be added to the group; press to add the general bell to the group.
: by successively pressing this key, you can choose whether the station concerned can transmit
a broadcast call.
: by successively pressing this key, you can choose whether the station concerned is subjected to
a broadcast call.
Notas : In a group with an external loudspeaker, the following rights must be observed: for the sta-
tions: transmission = YES, reception = NO; for the loudspeaker: transmission = NO, re-
ception = YES
OPERATOR STATION GROUP - ATTGRP
After pressing , enter the group index and validate. The directory number of the first station
in the group is displayed.
makes it possible to add a station directory number to the group. Enter the number of the station
to be added to the group.
proposes another destination; by successively pressing this key, you can choose the destination
(General bell, Welcome 1 to 8) then validate.
makes it possible to define the dynamic routing mechanisms for operator station group calls:
- and make it possible to define whether the dynamic distribution (time-outs T1 and T2,
destinations) criteria for each type of call (external or local) are active or not:
• makes it possible to define a destination station (or hunting group) or a collective speed
dial number for the dynamic routing in the case where the call has not been answered after a
time-out TP1 (12 seconds by default).
• : by successively pressing this key, you can define whether the time-out 1 is active (TP1) or
inactive (tp1).
• : by successively pressing this key, you can define whether the time-out 2 is active (TP2)
or inactive (tp2).
- or : by successively pressing this key, define whether the system should route the
call to the operator and/or the general bell after the non-response time-out TP2 has lapsed
(active = ATTD or GBEL; inactive = attd or gbel).
BR
O
AD
C
A
ADD
O
THER
TRANS
RECEPT
ATT
G
RP
A
ADD
OTHER
DYNR
OU
EXTERN L
OC
AL
N
U
MBER
TP1
TP2
OPERAT GENBEL

Alcatel OmniPCX Office Specifications

General

VoIP Support	Yes
SIP Support	Yes
ISDN Support	Yes
Analog Support	Yes
Integrated Voice Mail	Yes
Auto Attendant	Yes
Conferencing	Yes
VoIP Protocols	SIP, H.323
Power Supply	100-240 VAC, 50/60 Hz
Network Interfaces	10/100 Mbps Ethernet
Humidity	10% to 90% non-condensing