Alcatel OmniPCX Office Technical Documentation

DECT MMC STATION
Ed. 042/4 Réf. 3EH 21000 BSAA
MODIFICATION OF THE SYSTEM ARI - ARI
When a system is put into service for the first time, its ARI (Access Right Identifier) has the default value.
If there are two ALCATEL DECT systems which belong to two different clients but which have the same
radio signalling zones, the default values must be modified and a different ARI value assigned to each
one of the systems. After modification of the ARI, the base stations are informed of the new ARI.
After pressing , enter 11 octal digits, the first being non-modifiable (always equal to 1) and the
last being equal to 0 or 4.
ADDITION OF DECT MOBILE DATA - NEWHDS
makes it possible to create new data structures for DECT mobiles.
Data associated with a DECT access - VISIT
makes it possible to create data associated with a DECT access specified as a visitor. This DECT
access is then used to record a DECT station subsequently (UA or GAP).
Data associated with a GAP DECT handset - GAP
This command makes it possible to automatically register a new GAP DECT handset. This registration
is based on the reception of an access right sent by the GAP DECT handset (after a manoeuvre on the
part of the user). Only one GAP DECT handset can be registered at a given time.
makes it possible to select a permanent association to the system.
makes it possible to select a temporary association with the system; enter the date on which the
mobile is to be automatically disconnected from the system and validate.
makes it possible to define the operating mode for the GAP DECT handset: Bas, Enh or UA
(WUA: significant choice for UA + GAP DECT).
Data associated with a UA DECT handset - WUA1
A UA DECT handset is registered manually by entering its IPUI.
makes it possible to select a permanent association with the system.
makes it possible to select a temporary association with the system; enter the date on which the
mobile is to be automatically disconnected from the system and validate.
makes it possible to modify the DECT handset IPUI value; enter 14 octal digits and validate.
ARI
ADD
A
VI
S
IT
PERM
VISIT
M
O
DE
PERM
VI
S
IT
IP
U
I

Alcatel OmniPCX Office Specifications

General

VoIP Support	Yes
SIP Support	Yes
ISDN Support	Yes
Analog Support	Yes
Integrated Voice Mail	Yes
Auto Attendant	Yes
Conferencing	Yes
VoIP Protocols	SIP, H.323
Power Supply	100-240 VAC, 50/60 Hz
Network Interfaces	10/100 Mbps Ethernet
Humidity	10% to 90% non-condensing