Chapter 3 Measurement Examples
3-14.
15. Change the color of the characters on the button to green by clicking
on at All Outputs. Check the following items.
•
The Output lamps 1 to 4 on the BERT panel are lit. (Refer to
Figure 2.2.1-3.)
•
In the application window, the SYNC Loss and Error indicators
are off.
16. Change the color of the characters on the button to green by clicking
at All Measurements. When the time set at Gating elapses, the
measurement values are displayed at ER, EC, CC and FREQ (kHz).
To Next Page
Loading...
