AudioCodes Mediant 800 MSBG - Proxy and Registration

CLI Reference Guide 100 Document #: LTRT-17940
System and VoIP Functionalities
5.13.5 proxy and registration
This command defines proxy and registration settings.
Syntax:
sip-definition proxy-and-registration
set <parameter> <value>
The command’s syntax format is described below:
Arguments Description
<parameter> <value> Sets the following table parameters:
 always-use-proxy
 authentication-mode
 challenge-caching
 cnonce-4-auth
 defaults
 dns-query
 enable-proxy
 enable-registration
 fallback-to-routing
 gw-name
 gw-registration-name
 ip-addrr-rgstrr
 mutual-authentication
 nb-of-rtx-b4-hot-swap
 password-4-auth
 prefer-routing-table
 proxy-dns-query
 proxy-ip-lst-rfrsh-time
 proxy-name
 re-registration-timing
 redundancy-mode
 redundant-routing-m
 reg-on-conn-failure
 reg-on-invite-fail
 registrar-name
 registrar-transport
 registration-retry-time
 registration-time
 registration-time-thres
 rte-tbl-4-host-names
 set-oos-on-reg-failure
 sip-rerouting-mode
 subscription-mode
 use-gw-name-for-opt
 user-name-4-auth
For a description of these parameters, refer to the User's Manual.