AudioCodes Mediant 800 MSBG - Configuring RTP Payload Types Settings; Media RTP-Payload-Types

CLI Reference Guide 5. VoIP Commands
Version 6.4 145 January 2012
5.24 Configuring RTP Payload Types Settings
The following defines how to configure RTP Payload Types settings.
5.24.1 media RTP-payload-types
This command sets the RTP default payload types.
Syntax:
media RTP-payload-types
set <parameter> <value>
The command’s syntax format is described below:
Arguments Description
<parameter> <value> Sets the following table parameters:
 NSE-payload-type
 RTP-redundancy-payload-type
 V1501-SPRT-payload-type-rx
 V1501-SPRT-payload-type-tx
 V1501-SSE-payload-type-rx
 V1501-SSE-payload-type-tx
 defaults
 fax-bypass-payload-type
 modem-bypass-payload-type
 no-operation-payload-type
 telephony-events-payload-type-rx
 telephony-events-payload-type-tx
For a description of these parameters, refer to the User's Manual.
Defaults
NA
Command Modes
Enable
Examples:
The following example defines the transmitted No Operation packets RTP Payload type.
(config-voip)# media RTP-payload-types
(media-RTP-payload-types)# set no-operation-payload-type 96