CLI Reference Guide 3. General Commands
Version 6.4 27 January 2012
3.7.2 debug speedtest
This command performs a network speed test against a provisioned file server.
Syntax:
The syntax of this command can include the following variations:
debug speedtest set download <down-url>
debug speedtest set upload <up-url>
debug speedtest set upsize <up-filesize>
debug speedtest run
debug speedtest show
The command’s syntax format is described below:
Arguments Description
<down-url> Defines the URL of the test file on remote server. Supported
protocols are HTTP and FTP.
<up-url> Defines the URL of the test location on the remote server
where data can be uploaded. Supported protocols are HTTP
and FTP.
<up-filesize> Defines the length of upload test file, in bytes.
Defaults:
By default, testing URLs are not defined and the upload test size is set to 500000 bytes.
Notes:
1. Set the download URL to point to a large file (e.g. more than 2MB) on a testing server.
2. To perform just the download speed test, do not configure an upload URL.
3. Once the download and/or upload URLs are configured, run the test using the "debug
speedtest run" command.
4. The test runs in the background, its status may be checked using the "debug speedtest
show" command. Enter the show command repeatedly until the test is complete.
5. DNS must be configured correctly for speed test URLs.
Command Modes:
Enable
Related Commands:
NA
Examples:
The following example performs a network speed test.
# debug speedtest set download
http://speedtest.bezeq.co.il/speedtest/random1000x1000.jpg
To Next Page
Loading...
