CLI Reference Guide 26 Document #: LTRT-17940
System and VoIP Functionalities
3.7 Debug Commands
3.7.1 debug log
This command displays debugging messages to the CLI session.
Syntax:
The syntax of this command can include the following variations:
debug log
no debug log
no debug log all
Defaults:
NA
Notes:
1. Activating the debug log facility will redirect the device error messages (e.g. Syslog
messages) to the CLI console as well as their original destination.
2. A ‘no’ command is supported for this command (no debug log), which disables the
logging facility.
3. When working via telnet/SSH, "debug log" affects only the current CLI session.
4. To cancel log display to all CLI sessions, use "no debug log all".
Command Modes:
Enable
Related Commands:
NA
Examples:
The following example upgrades and activates the logging facility redirection.
# debug log
To Next Page
Loading...
