AudioCodes Mediant 800 MSBG - Hunt-Or-Trunk-Group

CLI Reference Guide 5. VoIP Commands
Version 6.4 121 January 2012
5.16.6 hunt-or-trunk-group
This command defines the hunt or trunk group parameters.
Syntax:
gw hunt TrunkGroup <index>
set <parameter> <value>
The command’s syntax format is described below:
Arguments Description
<index> Defines the table row index.
<parameter> <value> Sets the following table parameters:
 FirstBChannel
 FirstPhoneNumber
 FirstTrunkId
 LastBChannel
 LastTrunkId
 Module
 ProfileId
 TrunkGroupNum
 defaults
For a description of these parameters, refer to the User's Manual.
Defaults
NA
Command Modes
Enable
Examples:
The following example enables the Profile iD.
(config-voip)# gw hunt TrunkGroup 4
(TrunkGroup-4)# set ProfileId 5