AudioCodes Mediant 800 MSBG - Configuring IPM-Detectors Settings; Media IPM-Detectors

CLI Reference Guide 5. VoIP Commands
Version 6.4 141 January 2012
5.20 Configuring IPM-Detectors Settings
The following defines how to configure IPM-Detectors settings.
5.20.1 media IPM-detectors
This command configures the IP Media detectors configuration.
Syntax:
media IPM-detectors
set <parameter> <value>
The command’s syntax format is described below:
Arguments Description
<parameter> <value> Sets the following table parameters:
 IPM-detectors-enable
 answer-detector-activativity-delay
 answer-detector-enable
 answer-detector-redirection
 answer-detector-sensitivity
 answer-detector-silence-time
 defaults
 energy-detector-enable
 energy-detector-redirection
 energy-detector-sensitivity
 energy-detector-threshold
For a description of these parameters, refer to the User's Manual.
Defaults
NA
Command Modes
Enable
Examples:
The following example enables the DSP IP Media Detectors.
(config-voip)# media IPM-detectors
(media-IPM-detectors)# set IPM-detectors-enable enable