AudioCodes Mediant 800 MSBG - Configuring Voice Settings; Media Voice-Processing

CLI Reference Guide 5. VoIP Commands
Version 6.4 135 January 2012
5.17 Configuring Voice Settings
The following defines how to configure Voice settings.
5.17.1 media voice-processing
This command enables the media voice-processing parameters.
Syntax:
media voice-processing <index>
set <parameter> <value>
The command’s syntax format is described below:
Arguments Description
<index> Defines the table row index.
<parameter> <value> Sets the following table parameters:
 AGC-disable-fast-adaptation
 AGC-enable
 AGC-gain-slope
 AGC-max-gain
 AGC-min-gain
 AGC-redirection
 AGC-target-energy
 defaults
 echo-canceller-NLP-mode
 echo-canceller-aggressive-NLP
 echo-canceller-enable
 echo-canceller-freeze
 echo-canceller-hybrid-loss
 high-pass-filter-enable
 idle-pcm-pattern
 input-gain
 jitter-buffer-minimum-delay
 jitter-buffer-optimization-factor
 max-echo-canceller-length
 silence-compression-mode
 voice-volume
For a description of these parameters, refer to the User's Manual.
Defaults
NA
Command Modes
Enable