AudioCodes Mediant 800 MSBG - Show Mode

CLI Reference Guide 5. VoIP Commands
Version 6.4 73 January 2012
5.2.8 show mode
This command displays VoIP interface table details.
Syntax:
The syntax of this command includes the following variations:
show voip interface network <vlan id>
show voip interface network description
The command syntax format is described below:
Arguments Description
<vlan id>
Specifies a valid VLAN interface ID in the range of 1 and 255.
Command Modes
Enable
Examples:
The following example displays interface VLAN 2 details:
# sh voip interface network 2
Name: M_12
Application Type: CONTROL
IP address: 10.12.60.66
PrefixLength: 16
Gateway: 0.0.0.0
Vlan ID: 3
Primary DNS: 0.0.0.0
Secondary DNS: 0.0.0.0
Uptime: 69:54:48
rx_packets 0 tx_packets 6
rx_bytes 0 tx_bytes 462
The following example displays brief descriptions for all interfaces.
# sh voip interface network description
Index Application Type IP Address Prefix Gateway
VlanID Interface Name
0 O+M+C 10.4.60.62 16 10.4.0.1
1 O+M+C
2 CONTROL 10.12.60.66 16 0.0.0.0
3 M_12
3 MEDIA 10.13.60.66 16 10.13.0.1
2 M_13