AudioCodes Mediant 800 MSBG - Show Voip Interface; E1;T1, Bri

CLI Reference Guide 6. Show Commands
Version 6.4 155 January 2012
6.2 show voip interface
The following commands define the show voip commands.
6.2.1 E1/T1, BRI
This command displays the current status, main PM parameters and main configuration
parameters to a specific PSTN interface (E1/T1 or BRI).
Syntax:
The syntax of this command includes the following variations:
show voip interface e1-t1 <slot/port>
show voip interface bri <slot/port>
The command syntax format is described below:
Arguments Description
slot Defines the module slot index as shown on the front panel.
port Defines the port index within the selected module.
Related Commands:
interface e1-t1 <slot/port>
interface bri <slot/port>
The above commands enter a specific PSTN interface (E1/T1 or BRI) configuration.
Notes
The displayed parameters depend on the protocol type.
Examples:
The following example displays the current status, main PM parameters and main
configuration parameters.
show voip interface e1-t1 1/1
show voip interface bri 1/2
Mediant 800 - MSBG# show voip interface bri 1/2
show voip interface bri 1\2
-----------------------------
module/port: 1\2
trunk number: 1
protocol: bri_euro_isdn
state: active
alarm status: LOS 0, LOF 0
d-channel status: not established
loopback status: no loop
main performance monitoring counters collected in the last 330
seconds:
Slips: 25 Slip seconds: 1